SPECIFICATION FOR STANDARD AMF PANEL 100 KVA

Cubicle type, base mounting control panel with hinged doors, un-drilled bottom gland plate, AL. Bus Bar and accommodating the following

SWITCH GEARS

  •   185A, 4 Pole Contactor for ALTERNATOR with Thermal O/L relay
  •   185A, 4 Pole Contactor for MAINS (OPTIONAL)

BACK-UP PROTECTION

HRC fuse for short circuit protection

MICROPROCESSOR BASED AMF MODULE ( TS1311 ) INCORPORATING

Functions

  •   Supply Failure Timer
  •   Restoration Timer
  •   3 Impulse automatic engine Start / Stop logic
  •   Mains / Generator Voltage & Frequency Sensing.

Multifunction Meter & PCC 0301 with Scrolling Readings for

  •   Water Temperature/ Lube Oil Pressure
  •   Voltage / Ampere/ Frequency / kW / kVA
  •   Running-hour counter

Fault Indication (LED Type)

  •   Over / Under Speed
  •   Fails To Start
  •   Low Oil pressure
  •   Battery Charger Failure
  •   High Engine Temperature

Electronic kWH meter (Counter Display)

Current Transformers

Relay

Earth Fault Relay (Electronic type)

Indications (LED)

  •   DG ON, Load on DG
  •   Mains ON, Load on Mains, Battery Charger ON

Push Buttons (AMF MODULE BY PASS MODE)

  •   Engine START / STOP ( Provided on Engine Controller )
  •   Generator Contactor CLOSE / TRIP
  •   Mains Contactor CLOSE / TRIP (If provided)
  •   Fault ACCEPT / RESET

BATTERY CHARGER

  •   SMPS Based Unit with inbuilt Auto/Manual & Float/Boost Facility
  •   DC Voltmeter & Ammeter (Separate)